Toyota Smart Key Programmer
Toyota Smart Key Maker
Toyota Smart Keymaker OBD for 4D Chip support in Toyota and Lexus. Smart key system, supports K line and CAN-BUS protocols. It is a safe and fast key programmer Only works with the 4D chip and smart key
-Only requires 20 seconds to make one key!
-It is safe for the security alarm system
-Supports all kinds of Toyota and Lexus smart key systems: supports K line and CAN-BUS protocols
-It is the most safe and fast key programmer device for Toyota and Lexus series
-Please read the operation instructions carefully before making a key
Using the tool:
-Using the main key to add the other keys
Connect the programmer to the OBD port of the car, there are some short beep sounds after power on, it enters auto search car status. Press the start button twice to wake up the anti-theft module. When the connection with the module is done successfully after 7 seconds, there is a long beep 4-5 sounds (4 sounds means the system is IV K system, 5 sounds means V CANBUS system). Wait 30 seconds, there are a long beep sounds, it means the car is entering into the adding key state.
-Adding smart key
Put the original car key (with the logo side) access to the start button, you may hear two beep sounds. SEC light will flash twice; within 5 seconds, put the key close to the start button, you should hear 2 beep sounds, SEC light will flash twice; after it- s learned the entire smart key, wait 30 seconds until SEC light begins to flash, and the car will close adaptation mode automatically.
If all keys are lost or only the vice key is available it's necessary to perform initialization:
Press constantly the LED button, and plug into the OBD port of the car, after two short beep sounds, stop pressing, it enters into auto search car status. Press the start button twice, in order to wake the anti-theft computer. When the connection with the Computer of car is done successfully after 7 seconds, there is a long beep 4-5 sound (4 sounds means the system is IV K system, 5 sounds means V CANBUS system), 5 seconds later, LED light goes out. Wait 10-16 minutes, there are a long beep sounds, and LED light flickers, it means the car has entered into study key state.
All keys lost matching mode: Add every smart key requiring programming (with the logo side) access to the start button; meanwhile you will hear two beep sounds. SEC light will shine twice; After you finish studying all the smart keys, wait 30 seconds until the SEC light is shining, the system will Auto-close study state
You must use the right new smart keymaker, and follow the correct steps above carefully otherwise you must accept the consequences for any damage. If the device cannot match the key and the LED light shines constantly, pleases clear the error code by using an anti-theft system product such as T300. After finishing programming keys, the keys can be used but if the SEC light is still turn on, maybe you have used the vice key, only the main key can manually close the study mode. Don- t try to open the cover of the programmer and dash board; otherwise you may cause serious damage. This machine is sold only for legal auto repair.
1 x Toyota 4D Chip OBD2 Keymaker
It is normal for antivirus to flag some diagnostic files (.exe etc) as virus or trojan. Always switch off antivirus in your computer before attempting to install any diagnostic software or the software may not install and essential diagnostic files may be corrupted. Do not use downloaded software, or older versions, only use the software supplied with the tool.
2 - 9 Units: $32.38
10 - 24 Units: $26.98
25 - 49 Units: $23.39
50 - 99 Units: $22.48
100 - 249 Units: $22.48
250 - 499 Units: $21.59
500 - 999 Units: $20.68
1000+ Units: $60.48